How do I get SS Pro to do a sweep?

audiguy · July 2009

If I click on sweep, and turn the excitation signal on, I just get some annoying low frequency buzz that never stops. Changing from Lin to Log just makes it sound different.

benfaber · July 2009

The length of the sweep (and periodic noise) in SignalScope Pro is tied to the FFT length used by the FFT analyzer. Increasing the number of spectral lines will increase the length of the sweep.

audiguy · July 2009

Thanks for that reply. I am not sure I understand your answer, but in response to it I decreased the number of spectral lines to the minimum. It still does the same thing. It just makes a low buzzing sound. It is nothing like a sweep at all and it goes on forever. Nothing I can do changes it.

benfaber · July 2009

Try increasing the number of spectral lines to the maximum of 4800 (that will increase the length of the sweep to 9600 samples, which is 0.2 seconds). If you need more control over your sweeps, you might want to check out SignalSuite.

audiguy · July 2009

I have Signal Suite as per my previous post about the cost of upgrading. Your solution worked. I wasn't thinking that the longest sweep would be .2 secs. That's quick.

Thanks

How do I get SS Pro to do a sweep?

Comments