dual microphone input
I'm looking for suggestions to get dual (cheap) microphone input for display in SignalScope. The critical issue is to be able to separate the microphone inputs and compare signals from a common source. This is for teaching purposes, to display time lags and amplitude changes, so the quality is not very important. (Did I say cheap?)
For example, its not clear if the Griffin iMic can be adapted for two micorphones. Another possibility would be to plug in two griffin iMics, each with its own microphone, but its not clear if this would cause my powerbook to self-destruct or whether SignalScope could simultaneously display both inputs.
Any feedback or suggestions is greatly appreciated.
john kubie
For example, its not clear if the Griffin iMic can be adapted for two micorphones. Another possibility would be to plug in two griffin iMics, each with its own microphone, but its not clear if this would cause my powerbook to self-destruct or whether SignalScope could simultaneously display both inputs.
Any feedback or suggestions is greatly appreciated.
john kubie
0
Comments
You could use two iMics to get two mics into SignalScope. However, you would have to make the two iMic input devices into an aggregate device in Audio MIDI Setup.
Depending on what kind of mics you use, and what their power requirements are, if any, it may be easier just to route one to the left input and one to the right input of your Mac's built-in audio input jack. If, for some reason, you can't use your built-in input, you could use a single iMic in the same way. Two inexpensive Radio Shack electret mics (typically battery powered) and an appropriate adapter could do the trick nicely.
Ben
Sorry for my ignorance.
If I read you correctly, the audio input jack, although a single jack, supports 2 inputs.
Is the jack the same as a headphone jack? Am I looking for a connector that is the same as a headphone connector? Will such a connector keep the 2 mics separate and be seen by SignalScope as 2 inputs?
Thanks, in advance.
john
Ben
I think I've almost got it. Tomorrow I'm planning on looking at a 4-channel microphone mixer sold by radioshack ($29). If I'm correct, this will have a stereo line out that should go into the audio input jack and be visible as 2 channels in SignalScope. Thanks again.
Thanks again,
john